// ---------------------------------------- // // The following SmartCAM code generator has been // created to generate NC code for the respective // machine and control combinations listed below. // // Due to differences in programming styles, // controller versions, and optional equipment, // SmartCAMcnc DOES NOT and CANNOT guarantee // that the NC code generated is correct for any // specific machine. Some modification to the code // generator to match your setup and output // requirements is likely necessary. // // Modifications to code generators do not TYPICALLY // require a significant amount of time. SmartCAM // customers with active SSA contracts are entitled // to support for their code generators from the // SmartCAMcnc Support Group. To contact them for // support, please send an email to: // Support@SmartCAMcnc.com. If you would like // information on purchasing SSA for your SmartCAM // products, please contact: Sales@SmartCAMcnc.com // // DISCLAIMER: It is the responsibility of the end // user to confirm and verify that the NC code // created by any code generator is accurate and // will not cause a machine malfunction which // could result in stock, tooling, machine, and/or // personal injury. // // SmartCAMcnc assumes no responsibility or // liability for any damage caused or alleged to // have been caused by the use of any of the code // generators it provides. // ---------------------------------------- //L-Tec Piecemaker //Control: L-Tec 810 //Feb. 13, 1991 @START % G31X#XPOSY#YPOSR @END #OFFBLK% @STPROF <<#ABSI#MOV>X#XPOSY#YPOSR> @ENDPROF <#CUTC> <#DCOMP> @RAP <<#ABSI#MOV>X#XPOSY#YPOSR> @LINE <#DCOMP> <#CUTC> <<#ABSI#MOV>X#XPOSY#YPOS>P @ARC <#DCOMP> <#CUTC> <#ABSI#MOV> @