//    ----------------------------------------
//    
//    The following SmartCAM code generator has been 
//    created to generate NC code for the respective 
//    machine and control combinations listed below. 
//    
//    Due to differences in programming styles, 
//    controller versions, and optional equipment, 
//    SmartCAMcnc DOES NOT and CANNOT guarantee
//    that the NC code generated is correct for any 
//    specific machine. Some modification to the code 
//    generator to match your setup and output 
//    requirements is likely necessary. 
//    
//    Modifications to code generators do not TYPICALLY
//    require a significant amount of time. SmartCAM 
//    customers with active SMA contracts are entitled 
//    to support for their code generators from the 
//    SmartCAMcnc Support Group. To contact them for 
//    support, please send an email to: 
//    Support@SmartCAMcnc.com. If you would like 
//    information on purchasing SMA for your SmartCAM 
//    products, please contact: Sales@SmartCAMcnc.com
//    
//    DISCLAIMER: It is the responsibility of the end 
//    user to confirm and verify that the NC code 
//    created by any code generator is accurate and 
//    will not cause a machine malfunction which 
//    could result in stock, tooling, machine, and/or 
//    personal injury. 
//    
//    SmartCAMcnc assumes no responsibility or 
//    liability for any damage caused or alleged to 
//    have been caused by the use of any of the code 
//    generators it provides.
//    ----------------------------------------

//03/28/90
//Machine Type: Linde Burner with Plasma Torch
//Control Type: Lind CNC Series Control

@START
%
#UPDATE(#RFEED)
#NEXTPT
#ONBLK G31 X#XPOS Y#YPOS R
 G05 X#XPOS Y#YPOS
 K#V1

@END
 M69
 M30
#OFFBLK%

@STPROF
<#MOV>< X#XPOS>< Y#YPOS>< F#RFEED>

@ENDPROF
#RESET(#FEED)
< #CUTC>

@LINE
< #DCOMP>
#IF(#U1=1)<< #MOV>< X#XPOS>< Y#YPOS>< #CUTC>< F#FEED> P>
#ELSE<< #MOV>< X#XPOS>< Y#YPOS>< #CUTC>< F#FEED>>

@ARC
#IF(#U1=1)<< #MOV>< X#XPOS>< Y#YPOS>< I#XCTR>< J#YCTR>< #CUTC>< F#FEED> P>
#ELSE<< #MOV>< X#XPOS>< Y#YPOS>< I#XCTR>< J#YCTR>< #CUTC>< F#FEED>>

@PAUSEON
#EVAL(#U1=1)

@PAUSEOFF
#EVAL(#U1=0)

@