//    ----------------------------------------
//    
//    The following SmartCAM code generator has been 
//    created to generate NC code for the respective 
//    machine and control combinations listed below. 
//    
//    Due to differences in programming styles, 
//    controller versions, and optional equipment, 
//    SmartCAMcnc DOES NOT and CANNOT guarantee
//    that the NC code generated is correct for any 
//    specific machine. Some modification to the code 
//    generator to match your setup and output 
//    requirements is likely necessary. 
//    
//    Modifications to code generators do not TYPICALLY
//    require a significant amount of time. SmartCAM 
//    customers with active SMA contracts are entitled 
//    to support for their code generators from the 
//    SmartCAMcnc Support Group. To contact them for 
//    support, please send an email to: 
//    Support@SmartCAMcnc.com. If you would like 
//    information on purchasing SMA for your SmartCAM 
//    products, please contact: Sales@SmartCAMcnc.com
//    
//    DISCLAIMER: It is the responsibility of the end 
//    user to confirm and verify that the NC code 
//    created by any code generator is accurate and 
//    will not cause a machine malfunction which 
//    could result in stock, tooling, machine, and/or 
//    personal injury. 
//    
//    SmartCAMcnc assumes no responsibility or 
//    liability for any damage caused or alleged to 
//    have been caused by the use of any of the code 
//    generators it provides.
//    ----------------------------------------

@COMMENTS

Machine: Okuma-5V-NC
Control: Fanuc 3M
Date:    March 1989


@START
%
(#S2 TAPE##FILE #DATE)
(#TLCMT)
#ONBLKG90G00X10.0Z10.0
G50S#S1
#SPMODES#SPEED#SPNDLM08
#NEXTPT
#MOVX#XPOSZ#ZPOST#TOFF
@TOOLCHG
G00X10.0Z10.0<#SPOFF>
M01
    
G00X10.0Z10.0
#SPMODES#SPEED#SPNDLM08
#NEXTPT
#MOVX#XPOSZ#ZPOST#TOFF
@END
G00X#XHOMEZ#ZHOMET0000M09
M02
#OFFBLK%
@STPROF
<#MOV><X#XPOS><Z#ZPOS>
@RAP
<#MOV><X#XPOS><Z#ZPOS>
@LINE
<#MOV><X#XPOS><Z#ZPOS><F#FEED>
@ARC
<#MOV><X#XPOS><Z#ZPOS><I#XCTR><K#ZCTR><F#FEED>
@FXD1
G33<X#XPOS>Z#ZPOSF#FTHRD
@FXD4
G33Z#ZPASSF#FEED
M03
G33Z#ZPOSF#FEED
@BAR
Z#ZPOSF.1
M05M09
G94X-1.8F100.M76
M84
Z.025T0809
M01(CHECKFEED)
M83
G04F1.
Z1.
@