//    ----------------------------------------
//    
//    The following SmartCAM code generator has been 
//    created to generate NC code for the respective 
//    machine and control combinations listed below. 
//    
//    Due to differences in programming styles, 
//    controller versions, and optional equipment, 
//    SmartCAMcnc DOES NOT and CANNOT guarantee
//    that the NC code generated is correct for any 
//    specific machine. Some modification to the code 
//    generator to match your setup and output 
//    requirements is likely necessary. 
//    
//    Modifications to code generators do not TYPICALLY
//    require a significant amount of time. SmartCAM 
//    customers with active SMA contracts are entitled 
//    to support for their code generators from the 
//    SmartCAMcnc Support Group. To contact them for 
//    support, please send an email to: 
//    Support@SmartCAMcnc.com. If you would like 
//    information on purchasing SMA for your SmartCAM 
//    products, please contact: Sales@SmartCAMcnc.com
//    
//    DISCLAIMER: It is the responsibility of the end 
//    user to confirm and verify that the NC code 
//    created by any code generator is accurate and 
//    will not cause a machine malfunction which 
//    could result in stock, tooling, machine, and/or 
//    personal injury. 
//    
//    SmartCAMcnc assumes no responsibility or 
//    liability for any damage caused or alleged to 
//    have been caused by the use of any of the code 
//    generators it provides.
//    ----------------------------------------

@COMMENTS

11/10/86
Machine: TRIAC MILL w/ PNC-3 control

@START
#ONBLK G70
 M06 T#TOOL
 #SPNDL S#SPEED
@TOOLCHG
 M05
 M06 T#TOOL
 #SPNDL S#SPEED
@END
 M05
#OFFBLK
*M02L
 
@STPROF
< #ABSI>
 G00 X#XPOS Y#YPOS
@ENDPROF
 G00 Z#ZPOS
@RAP
< #ABSI>
< G00 X#XPOS Y#YPOS>
@LINE
 G01 X#XPOS Y#YPOS FX#FEED< Z#ZPOS FZ#FEED>
@ARC
 #MOV X#XPOS Y#YPOS FX#FEED CX#XCTR Y#YCTR#UPDATE(#FEED)
@ZCLRMV
< #ABSI>
< G00 Z#ZPOS>
@ZCHKMV
< G00 Z#ZPOS>
@ZDPTHMV
< G01 Z#ZPOS FZ#FEED>
@DWELL
 G04 D#DWELL
@