//    ----------------------------------------
//    
//    The following SmartCAM code generator has been 
//    created to generate NC code for the respective 
//    machine and control combinations listed below. 
//    
//    Due to differences in programming styles, 
//    controller versions, and optional equipment, 
//    SmartCAMcnc DOES NOT and CANNOT guarantee
//    that the NC code generated is correct for any 
//    specific machine. Some modification to the code 
//    generator to match your setup and output 
//    requirements is likely necessary. 
//    
//    Modifications to code generators do not TYPICALLY
//    require a significant amount of time. SmartCAM 
//    customers with active SMA contracts are entitled 
//    to support for their code generators from the 
//    SmartCAMcnc Support Group. To contact them for 
//    support, please send an email to: 
//    Support@SmartCAMcnc.com. If you would like 
//    information on purchasing SMA for your SmartCAM 
//    products, please contact: Sales@SmartCAMcnc.com
//    
//    DISCLAIMER: It is the responsibility of the end 
//    user to confirm and verify that the NC code 
//    created by any code generator is accurate and 
//    will not cause a machine malfunction which 
//    could result in stock, tooling, machine, and/or 
//    personal injury. 
//    
//    SmartCAMcnc assumes no responsibility or 
//    liability for any damage caused or alleged to 
//    have been caused by the use of any of the code 
//    generators it provides.
//    ----------------------------------------

//12/21/87
//Wiedemann A-3050 Punch Press with 
//		 Allen Bradley 8200 Cosmos One

@START
%
X#XPOSY#YPOST#TOOLM03M06
#NEXTPT
@TOOLCHG
#EVAL(#V1=0)
#IF(#TOOL>#LTOOL)<
#EVAL(#V1=#TOOL-#LTOOL)
#EVAL(#V2=1)>
#IF(#TOOL<#LTOOL)<
#EVAL(#V1=#LTOOL-#TOOL)
#EVAL(#V2=-1)>
#IF(#V1>15)<#EVAL(#V2=#V2*-1)>
#EVAL(#TOOL=#TOOL*#V2)
<X#XPOS><Y#YPOS><T#TOOL><#PUNCH>
@STPROF
<X#XPOS><Y#YPOS><T#TOOL><#PUNCH>
@RAP
<X#XPOS><Y#YPOS><T#TOOL><#PUNCH>
@