SmartCAMcnc Technical Support SmartCAMcnc makes no guarantees of the function or accuracy of, nor provides support for this freeware utility. Reverse Code Generator (Windows NT, Windows XP) Installation: 1. Create a directory under sm9 called revgen.     mkdir C:\sm9\revgen 2. Copy the revnt40.zip file to this empty directory.     copy revnt40.zip C:\sm9\revgen 3. Unzip the revnt40.zip     pkunzip revnt40.zip 4. This utility by default assumes that smartcam is loaded in C:\sm9. If you have smartcam loaded on a different drive other than C: or you are loading revgen in a different path other than C:\sm9\revgen.. you then need to edit revgen.mcl and revgen.pcb to reflect these changes.    -To edit the revgen.pcb, Startup Visual CTK and read in     revgen.pcb. Then go under Resource/Properies and change     the macro path to the correct location of revgen.mcl 5. Edit the PMILL.INI (Production Milling), AMILL.INI (Advance 3d), or FFM.INI (FreeForm) under the PcbPaths section, add "options=C:\sm9\revgen\revgen.pcb" For an Example, the PcbPaths section may look like the following: [PcbPaths]     usrelmt=usrelmt.pcb     mchevnt=mchevnt.pcb     options=C:\sm9\revgen\revgen.pcb Note: options should reflect the correct path to the revgen.pcb. If you have loaded revgen in a path other than C:\sm9\revgen be sure options are set to the correct path. The Reverse Code Generator can be found here: RevGen - 1.5 Mb